I need a stroker crank for the Zx12r 60 or 61mm if any one have one for sale let me know

Hi me again 🥴 a few years ago I done the recommended fix to stop oil coming up the wires from the stator which was snip the wires and done a solder spade connection .but checking them today the plastic at the connectors is melted .where am I getting that kind of heat from . The big multi plug...

For those with a minor oil leak down the left side of the engine, one possible solution may be to replace the camshaft sensor O-ring. I'm 99% sure that with as much oil that is all over, that it's my valve cover gasket that needs replaced. But since this is going to be a $.50 job and super easy...

Hey Guys, I've bought an A model engine with a spun bearing and I've rebuilt it. However, when I've gone to fit the sump, it doesn't fit. Correct shape, but it seems to bottom out by a couple of mm on the oil pipes. The sump and a spare sump were loose in a box along with a load of other...

Been looking for a clean B model oem screen for awhile. Nothing. All I’ve seen is beat up, tabs broke off etc. So for $22 I gave it a try. I am pleasantly surprised. Not a oem fit but pretty close. So I thought I would pass the vendor along in case someone needs a cheap alternative. cmg