|Topic Review (Newest First)|
|12-13-2008 04:28 AM|
|KZScott||tell us the fault code and someone with a manual (i can do it) will look up your problem|
|12-13-2008 03:18 AM|
It should be a 3 second whirring noise and should be easy to hear. |
The flashing FI light means you have a current fault code, this link should help you determine what it is.
|12-12-2008 08:27 PM|
|XdtesZombie||I am not sure does it make a constant noise or just a short noise?|
|12-12-2008 10:28 AM|
is your fuel pump cycling on when you are having this problem? |
You should be able to hear it when you switch the key.
My fuel pump relay has been acting up recently.
|12-10-2008 11:04 AM|
Dont know if it helps, but I had an Air Pressure Sensor that was going out on my 12. Anytime I would get hard on the throttle for more than 5 minutes, she would stall out next time I came to a stop. Try to find someone with a shop manual, that way you can pull the code out and see what your flashing FI light is for |
|12-09-2008 07:45 PM|
|XdtesZombie||I dont have a power commander and I read that other thread but it doesnt seem to apply.|
|12-09-2008 03:24 AM|
is your PC3 linked to your brake switch? if so it is better to reconnect the wire to other power source. |
Power Commander Support F.A.Qs
|12-09-2008 12:06 AM|
Anything on this link worth trying ?. |
FI light, hard starting and stalling @ ZX12R ZONE.com
|12-08-2008 04:10 PM|
Fuel injection light flashing at start
My bike has seemed to develop a new behavior.Every once in awhile when I try to start it it just cranks over and wont fire,and while cranking the fi light is flashing.When I shut of key and turn it back on it starts or does this again but after another on off cycle will start and runs fine.I had a full service not too long ago and just installed k&n filters and a yoshimira rs-3 bolt on.Other than that its a stock 2001 no pc3.Anyone have any ideas?