I bought this bike as a starter bike a few months back and in the last 8 months she has blown 3 fuses and there's really no tale tell signs it's about to happen or any form of riding that causes it. We'll call these fuse blowings "events."
1st event: Cruising at 100mph at about 4,500rpm.
Is there anyone who can help me if my bike is okay, or just on the way down?
It started with a melted plug between the stator coil and the rectifier!
I just connected the wires (without a plug) and started testing according to the manual.
The stator resistance is about 1,2 ohm measured on a...
I have a problem.
A couple of months ago i bought a nice ZX-6R from 1999 with almost 46000KM on it. I have driven it only for 3 times. When driving it last time, i visited a friend and turned the bike of for about 30-60 minutes.When i wanted to start it again, it didn't start. I...
Just put in a new stator (Rick's Electric p/n 268359).
Alternator Output Voltage Check:
AB and C leads are putting out around 67 vac each and are pretty consistent as I revved up to 4000 rpm.
Reg/Rectifier Output Voltage Check:
Plugged stator connector to volt/reg connector. With engine...
So its a 2000 zx12r and I got it last month. Head light relays missing and a switch being used to bypass the relay so the lights could be used.
Ordered up the relays and installed them and no lights. Replaced the switch and boom I have lights. So I have power going to the Relay but its not...
First time actually posting something and I have to admit it ain't looking good...
Last ride I had with my beloved '03 B2 the engine started making some clunki9ng noise shortly after launching on highway...finding this extremely strange I stopped and my buddy and I checked the sound...
Alternator output voltage 79v @ 4000rpm on all 3 outputs.
Manual says it should be 85~120v @ 4000rpm.
What could cause this?
Battery reads 13.6v at 4000 rpm, lights on etc
Manual says 14.2v~15.2, but is this with lights etc on?
Going to test...