Kawasaki World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
282 Posts
Discussion Starter #1
How do you load your maps and the manual settings. Do you do what the instructions say. The reason why I ask is because I had a problem with my PC and Dynojet said that the bike has top be running to load maps or do the manual adjustments. What do you guys think?
 
G

·
Guest
Joined
·
0 Posts
I have found that after the bike has been sitting for a day or so, the 1st
time I turn the ign on the pc will "find the powercommander" .
Otherwise I have to run the bike to get communication,once this is
established you can stop the bike using the kill switch,but leaving the
key on and it should stay "connected".
Hope this helps some.

p.s You can upload a new map while the bike is running.
 

·
Registered
Joined
·
12,494 Posts
like Psycho said....

* open Powercommander program, hook up cables
* put bike in neutrtal, start bike
* after 15 seconds or so, switch kill switch to off (leave key on)
* turn switch back to run
* upload map
* set throttle position (full closed, wide open, ok)
* turn key off after 20 seconds, disconnect cable

this is how I do it..02 PMB, PC111r, full SS Muzzy
 
1 - 3 of 3 Posts
Top