Most people don't know this...but..the Zx-12r was designed by the engineers @ KHI to use Akro pipes. (Honest) Your bike was origionally ment to run with an akro setup. (Once it's installed, you'll understand what I'm talking about...and be glad you did.)
Sndnga, I would be willing to bet that you would never be able to tell the difference in regards to the full Titanium and the SS/Titanium or SS Carbon.
The extra cash you could save by going with the SS/TI system could allow you to make other upgrades which could improve performance much more than saving a couple extra pounds off the exhaust system.
Put the extra savings into regearing both front and rear/new air filters/ and PC111R (if you don't already have these).
If I recall, you stated in earlier responses that you weigh in around 250 lbs. The most cost effective performance improvement could be a decrease in your weight, not the exhaust. But, needless to say most of us could afford to loose a couple of lbs... <img src=http://www.ezboard.com/intl/aenglish/images/emoticons/frown.gif ALT="">
This is my second post but I've got a ZX12 A1 model and I'm not exactly sure what kind of sprocket and chain they are I'm 99% sure it's not what came on it and I'm only curious as what other people use to clean their chains. These are somewhat heavy bikes and myself being 250 lb help with chain...
I read a thread on another forum and someone commented that fitting a small turbo gives an almost constant boost even at low throttle. Sounded interesting to me but I've no idea what would be needed parts wise so the question is
What exactly is needed to fit a small turbo to an A model zx12r...
A little help required if possible please . So 3 years ago i bought this zx12r with shite chines fairings fitted very poorly . I am slowly working through this bike to get it as near to good as it gets . I removed tank cover and the front two fixings ,(right and left ) have been adapted to take...
2003 Ace Performance cyl head
A1 cams at 105/108 CL
2000 short block.
Cooper back cut trans
Stock crank and rods
KZScott preped Wossner 1199 turbo pistons.
Didn't want to let perfectly good parts sit on the shelf.... :)