Kawasaki World banner

Akropovic Surging

3383 Views 16 Replies 4 Participants Last post by  Guest
G
My bike runs great with my Akropovic pipe but I did notice some mild surging around 3 to 4K or so. Anyone else notice this? Ive got a PC3R that I havent installed yet that I hope will solve the problem. Have any of you guys had a dyno before and after with the pipe and then with the PC? What results.

</p>
1 - 4 of 17 Posts
Traditionally there is a bit of a spot around that point with the stock system that should improve with the pipe. However it may depend on your map, what map have you used? Have you tried checking out some of the maps on www.zx-12r.org in the performance >> fuel/timing mod section >> PCIII maps

Try them out and compare them to your present map and you may find some improvement. There is a mod that I have on my map that drastically reduced the on/off effect of the throttle, but it also made it run a bit rich, I am still in the process of leaning it out and finding a balance.

[email protected]
 
www.ZX-12R.org</font>
 
Top 100 Bike Sites</font></p>
I didn't notice any surging, but you may have a little, is it enough to cause problems at idle?

[email protected]
 
www.ZX-12R.org</font>
 
Top 100 Bike Sites</font></p>
ZX-12girl, can you email me the map and the description for what it is intended for.

I will post it on the site, after I put it in my PCIIIR of course.

Does it have the Cliff Randall mods for on/off response (modification of the 0,2,5% ranges?



Thanks,



Easyrider

[email protected]
 
www.ZX-12R.org</font>
 
Top 100 Bike Sites</font></p>
See less See more
Thanks, that sounds great.

[email protected]
 
www.ZX-12R.org</font>
 
Top 100 Bike Sites</font></p>
1 - 4 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top