They all stretch in the beginning of use. Most slow and almost stop stretching after a few hundred miles unless they are pure junk. BEST CHAIN is a loaded question... There are many best chains out there to be had that are best suited for particular reasons to a specific task at hand.
Least rolling resistance = NON O Ring
Strongest = Could be the one with the best materials and heat treating involved or it could the the over sized one that you need to dump for a smaller lighter chain.
Keep in mind that the best chain will only stay at peak performance if it's cleaned and maintained often and drowning a chain with nasty ass chain lube isn't the way.. I believe most here all believe in the WD40 method.. I do and it works like a charm, BUT I stay ahead of my maintenance..
Hi all. Are there any other fan switches which fit the A1 radiator or does anyone know the thread size?. Mine has gone open circuit so needs replacing. i will be fitting a manual switch in parallel as well ( want both just to be safe)
Hi all, I recently purchased a persimmon red ZX12R and have spent the past few weeks getting it how I want it, still got a long way to go, planning to turn it into a sort of semi drag spec street racer. Anyway...I have just fitted an LED tail light that I purchased off eBay, supposedly a direct...
Hi all, I'm not syncing my injectors but I've attached a vacuunm gauge to the end vacuum pipe & it's coming out at about 7 -8 HG
I think it should be up near 17 - 18 HG? I'm taking the reading from here,,,,,
Thanks for any help.
Seeing that i am completely rewiring my 12, and thinking about the charging system issues that plague these poor bikes, i searched on here and around the net and found that people have successfully used FH mosfet regulators.
I am familiar with these because i systematically upgraded all my...
On the 2000 A1 models, was the factory cooling fan aluminum blades or plastic blades? I have seen posts about a Muzzy aluminum blade fan upgrade. I think the 02-05 were plastic, but curious if the A1 came with a aluminum blades from the factory.