Kawasaki World banner

1 - 4 of 4 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter #1
are these pads hard to install?i have the calipars off.i understand springs are in there.anybody give me some tips/help,on pad install,does and donts.thanks.

</p>
 

·
Registered
Joined
·
13,069 Posts
Here you go save and print these....




Our lips met passionately in the dark... And then...... She closed her legs and broke my glasses......</p>
 

·
Registered
Joined
·
303 Posts
Discussion Starter #3
thanks rich,if i can only figure out how to get more than1/2 the page to print,i'll be set to take em to my bike to install the pads

</p>
 

·
Registered
Joined
·
14 Posts
When pushing back pistons be careful the other pistons do not 'pop' out.
before you push the pistons back in it is a good plan to give them a clean with brake cleaner and a toothbrsh, grease rear off pads and a tiny bit on the pin, but use thick brake grease so when it's hot it stays where you put it.

</p>Edited by: <A HREF=http://pub56.ezboard.com/ukawapat.showPublicProfile?language=EN>Kawapat</A> at: 9/11/02 2:34:28 am
 
1 - 4 of 4 Posts
Top