Ive replaced my RR , stator core now I'm blowing my 30amp main fuse after running approximately 2 to 5 minutes this happen a few times then my RR from RM stator failed again any one have this issure before
I tried PMing you this, but it says you chose to not receive PMs.
Rewire headlights back to factory and replace bulbs with OEM watt bulbs. There is a factory service manual here on the forums you can download.
Shouldn't be too difficult.
I know that when you add LED turn signals, you must have an inline resistor or they won't work. So I think your headlights (LED) were not designed for that system. You would have to wire BOTH headlights back to stock. If you haven't added anything else, like a cell phone charging port, etc, you should be good after replacing the fuse.
Hi I own a Zx9r c2 1997 , yesterday somebody reversed into her smashing the front fender and cracking the alternator case . The alternator case was easy to source but the fender is a different story where can I get one of these preferably in Kawasaki green
Step into my office.
Where is Vozzie, Go200, MarkPMB, Lie2me, Kiwi, ynot, edge2edge, Outsider and all you other old school post whores.
Geez i miss the good old days on the .org Had to pop in and say hi. My first stop was the old ignore thread. Mike it really does my heart good to see you...
I have been having charging issues I have replaced everything short of the flywheel . bottom line is my bike is eating batteries is this my stator , fly wheel or mr my RR
I have acquired a 03 stator and flywheel oem stator cover the 03 puts out 4 amps less at 31 amps the 01 puts out 35 amps...
in newto riding just got my first bike which is a 2001 zx12r and i’m loving this bike it’s insane been having it for about terror weeks and recently when slowing down i feel a vibration is thisa problem or normal
I've got a prarie 650 that will only start and run with full choke on, even after warming up. It will only idle, if I try to throttle up it dies, and then wont start without a lot of cranking. does anyone have suggestions ? The carb was rebuilt about 2 years ago and I haven't put 10 miles on it...