Kawasaki World banner
Cancel

HEADLIGHTS STOPED WORKING MY A1

378 Views 5 Replies 3 Participants Last post by  jonathanmagnabosco12, 
jonathanmagnabosco12
No headlights I checked the fuse in fuse box and main headlamp fuse behind battery they were not blown can someone help me I no this is a common issue with the 2000 zx 12r A1 any tips would very very appricated
Reply
Save
Like
1 - 6 of 6 Posts
B
Worth looking into the relay in the fusebox

stator connector and no headligths fix ** NEW PICS **
Reply
Save
Like
ninjayorkie
Do you know how to use a multimeter, if so check the yellow wire in the front lower righthand side of the fuse box for an AC voltage that comes from a stator wire, this trips the headlight relay in the fuse box when the engine is turning over or running.
Reply
Save
Like
  • Like
Reactions: 2
jonathanmagnabosco12
ninjayorkie said:
Do you know how to use a multimeter, if so check the yellow wire in the front lower righthand side of the fuse box for an AC voltage that comes from a stator wire, this trips the headlight relay in the fuse box when the engine is turning over or running.
Click to expand...
What type of solider did u use or any tips on the best to use forcthe wires at he plug from stator yo regulator
Reply
Save
Like
B
jonathanmagnabosco12 said:
What type of solider did u use or any tips on the best to use forcthe wires at he plug from stator yo regulator
Click to expand...
60/40 solder and use a decent size tip on your soldering iron. the gauge of the wiring is large so you'll need a bit of heat. Depending on the age of your wiring you might need a decent flux to get the solder to wet to the wires.
Reply
Save
Like
  • Like
Reactions: 1
jonathanmagnabosco12
bikerdude02 said:
60/40 solder and use a decent size tip on your soldering iron. the gauge of the wiring is large so you'll need a bit of heat. Depending on the age of your wiring you might need a decent flux to get the solder to wet to the wires.
Click to expand...
Thank u you are 100% accurate on what happened to my bike hopefully the realy is the only damage I replaced the fuse box I'm hoping thier is no damage to my regulator or my brand new stator that I just installed
Reply
Save
Like
  • Like
Reactions: 1
1 - 6 of 6 Posts
Kawasaki World
A forum community dedicated to Kawasaki Motorcycle owners and enthusiasts. Come join the discussion about performance, racing, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
ZX-12R General Motorcycle Discussions Member Classifieds ZX-14 Site Help and Suggestions
Top