Moose Racing heat shield works for the turbo stuff. And affordable.
The muzzy piping under the oil pan was too long. So at the elbow that turned up and followed the fairing relief hump was right next to the plastic. No room for air flow.
And melted my first 12s fairing. So if there is room for air to flow then that’s a good start.
Ouch, I would be pissed. Any time you can add heat shields to most areas, it's a good idea. I have heard of that multiple times and 100 dollar heat shield is worth it to save a set of irreplaceable fairings.
Anyone on here have one of these systems on their 12R?
I've been looking for a full exhaust system for a little while now for my 01' ZX-12R. Yes, I'm still running with the stock exhaust after 19yrs of ownership. I wanted to get an Akrapovic system but unfortunately the bike is just too old...
Hi all, I'm not syncing my injectors but I've attached a vacuunm gauge to the end vacuum pipe & it's coming out at about 7 -8 HG
I think it should be up near 17 - 18 HG? I'm taking the reading from here,,,,,
Thanks for any help.
Hi all. Are there any other fan switches which fit the A1 radiator or does anyone know the thread size?. Mine has gone open circuit so needs replacing. i will be fitting a manual switch in parallel as well ( want both just to be safe)
Hi all, I recently purchased a persimmon red ZX12R and have spent the past few weeks getting it how I want it, still got a long way to go, planning to turn it into a sort of semi drag spec street racer. Anyway...I have just fitted an LED tail light that I purchased off eBay, supposedly a direct...
Seeing that i am completely rewiring my 12, and thinking about the charging system issues that plague these poor bikes, i searched on here and around the net and found that people have successfully used FH mosfet regulators.
I am familiar with these because i systematically upgraded all my...