Kawasaki World banner

1 - 17 of 17 Posts

·
Registered
Joined
·
627 Posts
Discussion Starter #1
Hey Guys, such qusetion how to make 12 engine rev quicker, faster motor?
What I have to do?

Regards Tom
 

·
Registered
Joined
·
6,306 Posts
lighten the parts, and or increase the power. simple physics
 

·
Registered
Joined
·
1,943 Posts
Theory goes like this. I want the same event to happen faster.

1. No air cleaner - causes drag or slows the first step of the event.
2. Head porting - the air against the wall is not hitting a smoother event.
3. Cam lift - the door gap is too narrow to cool the room think. Wider open cools faster.
4. Spring retainers - weight loss of moving/reciprocating weight is next throughout the eng.
5. Turbo/superchargers - cause the event to happen faster.
6. Remove all you can off the bike/yourself think like a jockey - power to weight ratio increase.
7. Fuel trim - more fuel pushes the mass sooner/faster.

What did I miss?
 

·
Registered
Joined
·
627 Posts
Discussion Starter #6
Damn Hubz, this is pretty good info, You are getting older men.

1. done
2. done
3. Cam lift - the door gap is too narrow to cool the room think. Wider open cools faster.
4. Spring retainers - weight loss of moving/reciprocating weight is next throughout the eng.
5. do not want
6. Remove all you can off the bike/yourself think like a jockey - in progress
7. done - if we are talking about power commander
 

·
Registered
Joined
·
6,306 Posts
ti valves
ti rods
lightened/polished crank
 

·
Registered
Joined
·
627 Posts
Discussion Starter #9 (Edited)
If I decide I will purchase ti retainers and I can do crank polishing with balancing (also with rods and pistons balancing)
ti valves&ti rods are for wsbk/moto gp budget, i thought that maybe ti valves are in some decent price but they are not.. (those for enduro bikes, i didint fint any for 12)
 

·
Registered
Joined
·
6,306 Posts
ti valves are 135 each
 

·
Registered
Joined
·
627 Posts
Discussion Starter #13 (Edited)
I do have quick action throttle, rear sprocket 52 front 18.
Pretty fit and slim also....:) haha thanks guys

Doug told me not to do internal engine parts until I wont
loose some bike weight.
 

·
Registered
Joined
·
990 Posts
Why try to make it rev quicker when you can make it rev more and get more power??

There is no sense talking for improvement for the circuit.It pulls hard no matter.
Are you doing roll ons?Increase the rev limmiter,more power less changes.
Are you doing drag?All of the mods other members suggested and lots of practice!
 
1 - 17 of 17 Posts
Top