Kawasaki World banner

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Just wanted to say hello and jump into this board. I just purchased a clean electric blue 1999 ZX-9. The only gripe I have so far is the carbueration below 3K rpm. It's awful at times. The bike has a D&D slip-on and I'm not sure if it's been jetted or not. Any recommendations on clearing up this glitchy throttle response at those engine speeds. It's runs like a "bat out of hell" above that. Any info is appreciated



Kevin

</p>
 

·
Registered
Joined
·
303 Posts
Chances are it has not been jetted with just a slipon.

my d&d full system w/carbon can,and a stage 1 jet kit really woke up my 9r.i had the same problem and some adjusting by a good tech with the jet kit should cure your blues!

</p>
 
1 - 2 of 2 Posts
Top