Try again!! a case of digital spascticity again, fingers like pigs tits more like! sorry! Love the under tray, cracking! The more I look at the snout, the more I begin to like it, I could warm to it with time. Looks like you've been busy? Was there a lot of work involved in fitting everything? what's next on the agenda?
Have you been pulled for the plate yet? I had one on my ZXR750R and got pulled all the damn time!
Ever get down this neck of the woods? Questions, Questions!
The snout was dead simple to fit, you just slide it over the existing snout then secure it using the two existing screws…took me 5 mins.
The undertray however was a bit a lot more time consuming, it took me about 4 hours (hey I’m a slow worker), as you Thanks Ted
The snout was dead simple to fit, you just slid it over the existing snout then secure it using the two existing screws…took me 5 mins.
The undertray however was a bit a lot more time consuming, it took me about 4 hours (hey I’m a slow worker), as you have to strip out all of the original undertray, then faff about with the ECU and alarm locations, and cut holes in your tail piece, for the winkers.
my next plan is to fit a PC3r and K&Ns, and maybe a yellow box.
Funny you should ask me about being hassled by the feds for my plate. I went for a blast around the Mendips today, and on the way back home to Bristol, I was tooling along the M32, doing about 90ish, when a bike cop came up behind me and proceeded to follow me for about 5 miles. So I was waiting for a pullover signal (illegal plate, pipe, Simpson helmet with black visor), but he just overtook me, ‘and get this’, he gave me a little wave!!! No, I wasn’t dreaming, it actually happened!
and no, i don't seem to get down to the Reading area much, i do most of my riding around Somerset, Devon and Wales.
have you seen one of these?
i'd be lost without it now...its a digital gear indicator.
Minger, I want it, I want it, I want it! Where did you get the digital gear indicator? How much and how hard to install? <img src=http://www.ezboard.com/intl/aenglish/images/emoticons/smokin.gif ALT=":smokin">
2000 ZX12...purchased it non-running about 3 years ago. Finally tore into engine and found piston rings were melted to the pistons. Purchased new cylinder, rings, and put engine back together. The starter seems to make a bit of a screeching sound when turning the engine over. The bike will...
Hoping someone can help. I know zx12s run hot and have issues with heating up but what mine is doing can’t be normal.
on a run at any speed the temp is fine, either half way or just below it, if I’m stopped in traffic for 30 seconds, it’s up into the red and boiling the coolant out the over...
A while back I was on this forum and got some info about the oil pipes in the engine block with a photo showing the difference, the A model pipes were almost twice as narrow as the B model.
Does anyone know from which model year the wider pipes started and if they are a straight swap with the...
I am Curious if anyone on here has changed the speedometer and Tachometer gauges on their ZX12R for a more Modern Digital one and if so what one have they used?
I have a very difficult time seeing the speedometer on my cluster the Tachometer isn't much of an issue but between the...