Stalling after started up - Kawasaki Forum :: KawasakiWorld.com
 1Likes
Reply
 
LinkBack Thread Tools Display Modes
post #1 of 28 Old 07-01-2018, 02:35 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
Stalling after started up

And another bug to get worked out. When I start the bike it will run for a few seconds and then stall out. This will usually happen twice and on the third go will stay running. It will run fine for a few seconds then all of a sudden shut off
cybertech is offline  
Sponsored Links
Advertisement
 
post #2 of 28 Old 07-01-2018, 03:46 PM
Senior Member
 
dastardly's Avatar
 
Join Date: Aug 2014
Location: australia
Posts: 1,021
is this happening when the bike is cold or also when warm have you a pc if so disconnect and try again Craig

if anything goes wrong check the battery
no longer a rider but still an enthusiast
dastardly is offline  
post #3 of 28 Old 07-01-2018, 04:34 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
Happens both cold and hot actually just took it for a short run to go eat and it started perfect no problem and then when leaving was a night mare stalled a good 8 times I also notice the Roma will go up to alittle over 3000 rpm for a second then it shuts off
cybertech is offline  
Sponsored Links
Advertisement
 
post #4 of 28 Old 07-01-2018, 04:55 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
To add some.more to it doesn't seem like I'm.getting a proper tach signal on the gauge when it's having problems and if u keep the revs up it will help to save it when it wants to shut down some of the time once it's going a bit it's fine
cybertech is offline  
post #5 of 28 Old 07-02-2018, 02:10 AM
Senior Member
 
dastardly's Avatar
 
Join Date: Aug 2014
Location: australia
Posts: 1,021
have you done the reg mod this could be causing electrickery problems

if anything goes wrong check the battery
no longer a rider but still an enthusiast
dastardly is offline  
post #6 of 28 Old 07-02-2018, 05:00 AM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
I removed the connector from the stator and soldered it
cybertech is offline  
post #7 of 28 Old 07-02-2018, 09:14 AM
Senior Member
 
KZScott's Avatar
 
Join Date: Jan 2007
Location: Ontario, Canada
Posts: 6,246
Send a message via MSN to KZScott
what are you trying to run for an idle speed?

01 ZX-12R 8.84 @ 156.3 on dot tires, NA.... turbo 8.47 @ 164
00 ZX-12R 8.62 @ 165.2 no bars, slicks, 55 shot... turbo 8.32 @ 173
00 ZX-12R 1: 222.046 1.5: 226.390 Worlds Fastest NA Kawasaki
00 ZX-12R street turbo 1: 227.9 1.5: 234.1
00 ZX-12R LSR turbo 1: 263.1 1.5: 266.5 Worlds fastest ZX-12R CMG Racing RCC Turbos
KZScott is offline  
post #8 of 28 Old 07-02-2018, 01:46 PM
rmk
Senior Member
 
Join Date: Feb 2017
Location: Netherlands
Posts: 103
Garage
Quote:
Originally Posted by dastardly View Post
have you done the reg mod this could be causing electrickery problems


Catweazle fan?
Duck00 likes this.
rmk is offline  
post #9 of 28 Old 07-02-2018, 03:10 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
Never tried for a target idle speed yet just want to get it running decent what's your advice there?
cybertech is offline  
post #10 of 28 Old 07-02-2018, 04:43 PM
Senior Member
 
KZScott's Avatar
 
Join Date: Jan 2007
Location: Ontario, Canada
Posts: 6,246
Send a message via MSN to KZScott
well too low and it will stall, a lot of guys try to go under 1000 rpm. i prefer 1200. it will also stall at idle rpm if its too rich in a lot of cases

01 ZX-12R 8.84 @ 156.3 on dot tires, NA.... turbo 8.47 @ 164
00 ZX-12R 8.62 @ 165.2 no bars, slicks, 55 shot... turbo 8.32 @ 173
00 ZX-12R 1: 222.046 1.5: 226.390 Worlds Fastest NA Kawasaki
00 ZX-12R street turbo 1: 227.9 1.5: 234.1
00 ZX-12R LSR turbo 1: 263.1 1.5: 266.5 Worlds fastest ZX-12R CMG Racing RCC Turbos
KZScott is offline  
post #11 of 28 Old 07-02-2018, 06:21 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
I just tried loading the map.from pc and the bike ran really rough was hesitating like crazy but stayed running but I noticed sitting at idle the tach would stay at 0 the pc software shows it around 1200-1300rpm then I loaded another map a member sent me and back to stalling like crazy but the tach was reading if the pc is causing the problem do i have to get a new one?
cybertech is offline  
post #12 of 28 Old 07-02-2018, 07:34 PM
Senior Member
 
KZScott's Avatar
 
Join Date: Jan 2007
Location: Ontario, Canada
Posts: 6,246
Send a message via MSN to KZScott
you could try a firmware update

01 ZX-12R 8.84 @ 156.3 on dot tires, NA.... turbo 8.47 @ 164
00 ZX-12R 8.62 @ 165.2 no bars, slicks, 55 shot... turbo 8.32 @ 173
00 ZX-12R 1: 222.046 1.5: 226.390 Worlds Fastest NA Kawasaki
00 ZX-12R street turbo 1: 227.9 1.5: 234.1
00 ZX-12R LSR turbo 1: 263.1 1.5: 266.5 Worlds fastest ZX-12R CMG Racing RCC Turbos
KZScott is offline  
post #13 of 28 Old 07-02-2018, 07:50 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
Just did that too
cybertech is offline  
post #14 of 28 Old 07-03-2018, 04:20 AM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
Going away for a few days when I get back I'm going to unhook the pc and see what happens
cybertech is offline  
post #15 of 28 Old 07-10-2018, 06:05 PM Thread Starter
Senior Member
 
Join Date: May 2015
Location: Ontario,Canada
Posts: 137
Disconnected the pc and seems to be running fine
cybertech is offline  
Reply

  Kawasaki Forum :: KawasakiWorld.com > Kawasaki Motorcycles > ZX-12R

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Kawasaki Forum :: KawasakiWorld.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Similar Threads
Thread Thread Starter Forum Replies Last Post
Well damn, clutch started to slip... Mefirst ZX-12R 34 06-24-2018 04:03 PM
My 12r possibly just started overheating? stube40 ZX-12R 11 10-25-2017 09:59 PM
Stalling with clutch engagement kaboom ZX-9R 4 08-26-2017 05:36 PM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome