Kawasaki World banner

Just bought my first ZX12!

2 reading
35K views 283 replies 31 participants last post by  H1OFF1CER  
Hea man I feel for you, I could help if I was there with you, but I'm not!
Try down load a set if instructions from another manufacturer, checking to match your positives and negatives of each module,try to be neat by using the end of the wiring at the block connectors or even remove them.
A mock up run before you install them on the bike first should get your brain juices flowing.
Slowly slowly catch the monkey, take your time and don't forget to use your fuses , wiring diagram from Kawasaki, a good soldering iron, plenty of cable ties as you don't want a rattle fault to appear later on and always remove the battery terminal , best of luck
 
Help...
12r died today,
A lot of start stop today, maybe 10-12 stop and starts,
Last moments started chugging at 9k rpm,
Pulled into service station thinking it was out of fuel,
Seemed ok ,
Left it running while checking the tire pressure,
Then it cut out,
would not start, no click from starter motor, like dead battery,
Turned it off and on a few times, clocked went a bit funny, spinning up half way , digital display was coming on and off.
Have left it to collect in morning,
New battery 6 weeks ago,
Any suggestions?