Anyone else having problems with the muzzy ZX12 lockup? Problem seems to be that the clutch pusher is flexing, allowing the clutch release lever to slip off of the "head" of the pull shaft, then it binds and the clutch is then unusable (no "declutching" possible). This is not a problem with having too much weight or pulling the clutch in at high RPM, as it will do it at idle, even after a few seconds after the clutch pressureplate and lock-up has stopped rotating. The clutch puller is not bent, Tried different stack heghts, and even shimming the pull rod to enable different degrees of rotation for the clutch release lever, but no luck. Seems to be a design flaw / incomplete design, allowing the pusher to flex. Is the MTC clutch better? (ANYTHING would be better than this....seems to need an outer support on the pull rod or a modified clutch release lever)
Sportbikeryder
Joined
·
17 Posts
Hello, I have a Muzzy lock-up clutch on my zx12,with the Muzzy clutch mod (hub and thicker steels etc.)and it worked perfectly for about 200 passes at the strip.Thanks Chuck Warner-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
